Steering Dampener; Control Lever Adjustment; Park Brake Adjustment - Land Pride Accuz Z52 , Z60, Z72 Operator's Manual

Land Pride
Section 3 Adjustments

Steering Dampener

Refer to Figure 3-5:
The steering dampeners are incorporated into the unit to
provide some resistance when the control levers are
moving forward or rearward. To set the steering
dampeners in the correct operating position follow these
steps:
1. Place the control lever in the neutral position.
2. Check the center distance from the dampeners front
mounting hole to the rear mounting hole. This
dimension should be 8 9/16". If it is not, loosen the
front attaching bolt and slide the dampener in the
mounting slot until this dimension is attained.
Re-tighten front attaching bolt.
NOTE: The dampener must not bottom out when the
pump lever is fully stroked in either direction.
Steering
Dampener
Steering Dampener Adjustment
Figure 3-5

Control Lever Adjustment

The control levers can be adjusted for operator comfort.
By loosening the cap screws that attach the upper control
lever to the lower lever (Fig. 5-6), the upper control lever
can be pivoted to fit the operator s personal preference.
03/11/03
The control levers should be adjusted so that they align
with each other when in the neutral position.
Cap Screw

Park Brake Adjustment

8.54"
Occasionally check the park brakes and adjustment using
the following method:
1. Position the control levers in the neutral position.
!
Make certain mower is secure when it is raised and placed on
the jack stands. The jack stands should not allow the mower to
move when the engine is running and the drive wheels are
rotating. Use only certified jack stands.
NOTE: The front brake link is not adjustable. Refer to
Figure 3-7.
19081
Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M
Lower
Control
Lever
Control Lever Adjustment
Figure 3-6
Disengage the deck clutch.
WARNING!
Upper
Control
Lever
19082
23