Table of Contents
Advertisement
Section 3: Adjustments
Section 3: Adjustments
!
WARNING
Unless specifically required, Do Not have engine running
when servicing or making adjustments to the mower. Place
both control levers in the park position and remove ignition
switch key. Read and observe all "Safety Warnings" and
"Important Notes" in this manual.
Repairs or maintenance requiring engine power should be
performed by trained personnel only. To prevent carbon
monoxide poisoning, be sure proper ventilation is available
when engine must be operated in an enclosed area.
Your Zero Turn Mower was adjusted before it left the
factory and checked for proper operation during
pre-delivery set-up. However, break-in wear and
continued use can cause some adjustments to change.
•
Be alert for unusual noises while operating the mower.
They could be signaling a problem.
•
Visually inspect for abnormal wear or damage while
servicing and making adjustments to the mower.
Proper servicing and adjustment is the key to the long life
of any implement. With careful inspection and routine
maintenance, you can avoid costly downtime and repair.
!
WARNING
Keep your mower clean. Remove heavy trash and clippings
from mower. Keep all moving parts, hydraulic system, engine
cooling system, and exhaust system clean of trash and
clippings. Accumulation of trash and/or clippings can cause
fires, hydraulic overheating and excessive belt wear.
Clear away heavy build-up of grease, oil, and dirt.
Especially clean in the areas around oil openings, fuel
openings, and air inlets. Minute dust particles are
abrasive to close-tolerance engine and hydraulic
components.
Some repairs require the assistance of a trained service
mechanic and should not be attempted by unskilled
personnel. Consult your Land Pride service center when
assistance is needed.
Torque Requirements
Refer to "Torque Values Chart" on page 52 to determine
correct torque values when tightening hardware. See
"Additional Torque Values" at bottom of chart for
exceptions to standard torque values.
Tire Pressure
Before considering any adjustment, check tire air
pressure. Unequal tire pressure will cause mower to drift
to one side. Refer to "Tire Inflation Chart" on page 53.
12/15/15
Table of Contents
Seat Adjustment
Refer to Figure 3-1:
The seat should be adjusted forward or rearward to a
comfortable position to operate the deck lift pedal.
1.
With operator seating in the seat, place his or her
right foot on the deck lift pedal.
a. Determine if the seat is too close to the pedal, too
far away, or at the correct distance.
b. If the seat is at the correct distance, skip to
"Steering Adjustments" on page 22.
c. If the seat needs adjusting, determine how many
inches it should be moved and in which direction it
should be moved. (forward or rearward)
2. Release spring loaded seat latch. See "Accessing
Area Beneath the Seat" on page 14 for instructions
on how to operating the spring loaded seat latch.
3. Rotate seat pan (#2) up and loosen all four
5/16"-18 x 3/4" GR5 cap screws (#3).
4. Slide seat forward or rearward by the predetermined
inches in step 1c above.
5. Retighten cap screws (#3) to the correct torque.
6. Rotate seat down until the spring loaded seat latch
catches on the seat pan.
7.
Reinstall removed hardware in seat latch to prevent
someone from opening the seat platform easily.
Seat Adjustment
Figure 3-1
ZST40 & ZST48 Zero Turn Mowers 357-505M
33199
21
Advertisement
Table of Contents
