Troubleshooting - quest roam SiPix Owner's Manual

Troubleshooting

Problem
The camera has
no power.
The camera won't
take a picture.
The flash doesn't
work.
The image is
blurry.
The image is too
dark
The image is too
light.
Camera beeps after
I insert the batteries. before inserting the AA
Possible cause
The camera is off.
The batteries are
discharged.
The batteries are inserted
incorrectly.
Ensure that the Standby
LED is on and is not
flashing.
Is the camera's memory
full?
Is the camera connected
to a computer?
Is the flash on?
The batteries my be weak.
The camera or subject was
moving when the shot was
taken.
The flash is needed for the
shot.
You are facing a bright
light when taking the
pictures.
The coin battery was inserted Remove the AA and coin batteries.
batteries
Solution
Make sure that the main switch is
not set to OFF.
Replace the batteries with new or
freshly charged ones.
Check the battery orientation.
If the LED is flashing, wait until
it emits a steady light before
taking the picture.
If the memory is full, you cannot
take any more pictures. Check
the remaining shots and delete
some pictures to free up memory.
The camera's buttons are not
functional when connected to a
PC. Disconnect the camera to
take more pictures.
Ensure that the flash is set to
Automatic Flash.
If the batteries are too weak, the
flash is unable to recharge. Turn
the camera off and wait a few
seconds before turning it back on.
If this doesn't work, you need to
replace the batteries.
Hold the camera steady or put it
on a tripod to take pictures.
Or ensure that the camera focus is
set the appropriate mode.
Turn the flash to Automatic Flash.
Change the angle of the shot so
that any bright lights do not
shine directly towards the camera
lens.
Insert the AA batteries then the coin
battery.
27