Lance-Larkin BREW EXPRESS BE-112 Operation Manual

Lance larkin brew express coffeemaker operation guide

Hide thumbs Also See for BREW EXPRESS BE-112:

Supplementary manual (1 page)

Installation manual (11 pages)

Operation manual (12 pages)

Table Of Contents

Table of Contents

Quick Links

Need help?

Do you have a question about the BREW EXPRESS BE-112 and is the answer not in the manual?

Questions and answers

Summary of Contents for Lance-Larkin BREW EXPRESS BE-112

Page 1 XPRESS ™ OperatiOn GUiDe Be-112 model no. For more information see our instructional video online at wwww.BrewExpress.com.
Page 2: Table Of Contents
1. Safety 2. Features 3. Controller Functions 4. Start Up 5. Operation 6. Maintenance 7. Troubleshooting 8. Parts & Service 9. Frequently Asked Questions 10. Warranty Information COnt en ts 6 -7 9 - 11 13 - 15...
Page 3: Safety
safety IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all Instructions. 2. Do not touch hot surfaces. Use handles or knobs. 3. The voltage and frequency of the supply connections should conform to those of the rating label. 4.
Page 4: Features
featUres Convenient and practical. Brew Express™ is plumbed into the wall and fills on command so you never have to manually fill with water. Handsome Euro design compliments any decor. Need additional outlets? Brew Express™ offers you two. Large, bright and easy to read LED display.
Page 5: Start Up
start Up IMPORTANT: Please read and follow instructions carefully before starting your BREW EXPRESS™ in-the-wall COFFEE SYSTEM. Did you purge water lines during installation to remove any foreign particles (debris) in lines? Debris in water lines can clog brewer system causing failure, and VOID ALL WARRANTIES. The BREW EXPRESS™ dispenses extremely hot water. Hot liquids may cause severe burns if it contacts skin. Use ex- treme caution when handling hot liquids dispensed by the BREW EXPRESS™. KEEP HANDS AWAY FROM SPRAY HEAD, BREW BASKET, CARAFE OR MUG DURING BREW CYCLE. Make sure water is “ON” prior to starting BREW EXPRESS™. The BREW EXPRESS™ will not operate if there is no water or water pressure is less than 30 psi. Make sure power is supplied to the BREW EXPRESS™. Power is supplied when the LED display is illuminated on the display panel.
Page 6: Maintenance
OperatiOn 5. Manual Brew Cycle To manually start a brew cycle move the slide switch from OFF to ON. If the switch is already in the ON position, switch it to the OFF position and then back to ON. The brew light will turn on once the cycle has started. If brewer is cold, the heater will preheat the water before starting the brew cycle.
Page 7: Troubleshooting
trOUBleshOOtinG Display is not illuminated • Ensure the power to the rough-in box is turned on (check circuit breaker). • Ensure brewer is fully pressed into the rough-in box. • Ensure the outlet inside the rough-in box is properly wired. Remove the brewer and check outlet with volt meter.
Page 8: Parts & Service
trOUBleshOOtinG Carafe or Mug not detected (flashing brew light) • IRD cannot detect flat black or clear glass mug (change mug color) • IRD window is dirty (wipe with moist towel and dry) • Mug not close enough to IRD (move farther into brewer) • IRD is not set properly, call for technical service. Water dripping from spray head •...
Page 9: Frequently Asked Questions
freqUently askeD qUestiOns What type of coffee filter do I use? For Standard size Brew Basket: Flat 10 to 12 cup filter (recommended brand Bunn or Brew Rite) *Please Note: A 8-12 cup filter will not work properly because the sides of the filter are not high enough to hold all the coffee grounds appropriately.
Page 10: Warranty
freqUently askeD qUestiOns Water Pressure: What is minimum and maximum water pressure? The Brew Express specifications require a minimum of 30 psi to a maximum of 90 psi. If it is lower than 30 psi, it is possible the pressure sensor will not allow the Brew Express to work. You will get an “EEEE” message. This can mean no water;...