Global JUNO-NET Operation & Maintenance Manual page 26

JUNO-NET
MAINTENANCE
The IR Keypad is typically the most convenient method to program the system. The sensor for the IR
Keypad is just below the SOUND ALARMS button on the Main Panel and on a Repeater. Each time a
key is pressed on the IR Keypad the Main Panel will beep.
If no beeps are audible then check the batteries in the IR Keypad.
The IR Keypad uses 2 x AAA batteries.
The IR Keypad Keys
To access the characters in RED , first press the SHIFT KEY. To return to the characters in BLACK press
the SHIFT KEY again.
Each time a key press is received by the panel the panel emits a beep. The beeps when SHIFT is on
are of a higher pitch than when SHIFT is off.
0-9 are used to input numbers
and are used to select items
B-SP and are often used to change fields (move the cursor)
+/- are often used to select the loop
ENTER is used to select items and to store changes
ESC is used to abort changes and exit
HOME is often used to go back to the start of a function
Pressing both EXIT keys exits programming mode.
Help
Where possible help is displayed automatically. However additional help is sometimes available if you
press the help key ':' the colon.
The first press will display help for 7 seconds, a second press will ensure the help is displayed for 20
seconds. Pressing any key whilst help is displayed will clear the help but this key press will be ignored.
25
OPERATION & MAINTENANCE MANUAL
REVISION 0.7a
16-04-2004