Summary of Contents for Ofna Racing Hyper7TQ Sport
Page 1
SUPPLEMENTAL MANUAL Sport 1:8 SCALE GAS POWERED OFF-ROAD BUGGY INSTRUCTION MANUAL PLEASE READ INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING THIS MODEL. KEEP THIS MANUAL FOR PARTS NUMBERS WHEN ORDERING . SPECIFICATION ARE SUBJECT TO CHANGE WITHOUT NOTICE.
REQUIRED FOR OPERATION THINGS NEED BESIDES THE KIT Bottle’s with spout # 10160 - large 500cc # 10161 - large 500 ccAuto Stop 3.5 cc (21 Class) ENGINE # 10162 - small 250cc # 10164 - CNC spout 500CC REAR EXHAUST # 10167 - CNC spout 800CC OFNA/Picco P7-R...
Page 3
READ THIS BEFORE RUNNING Running a nitro kit is fun and easy, but to make this a safe • Clear oil and dirt from chassis with a degreaser. and good experience you must observe a few rules. This Precautions kit is extremely fast, easily over 40MPH, and can seriously •...
Page 4
#10021 - Black ASSEMBLY OF THE AIR FILTER #10027 - Yellow #10028 - Pink #10029 - Blue Nylon Strap Nylon Strap ( Small ) Air Filter Connector ( Small ) Air Filter Sets #10135 - Black $8.95 #10137 - Yellow $8.95 Sets includ tube, foam filter pre-filter, oil bottle #10016...
Page 5
SETTING THROTTLE LINKAGE * ADJUSTING THROTTLE LINKAGE BEFORE START THE ENGINE 1. Turn on your transmitter at first and then the car's electronics (Set the transmitter trim-level in center). Adjust the alum. stopper A to made the carburetor in idle position. Adjust the alum. stopper B to leave 2mm space between alum.
Page 6
• TROUBLE SHOOTING GUIDE PROBLEM CAUSE SOLUTION Fuel line not primed Fill fuel tank and pressurize tank by capping exhaust ENGINE WILL NOT START Glow plug will not heat(lite) Check glow plug battery heater or replace plug. Engine flooded, too much fuel Check carb.
Page 8
HYPER 7 PART NUMBER CROSSOVER HYPER 7 PART NUMBER CROSSOVER Part No.# Crossover (use only OFNA part numbers) OFNA Hyper Description Retail 10010 CLUTCH SHOES, 3 PCS. 12.95 10090 CLUTCH NUT, PILOT SHAFT 8.50 10100 E-10 CLUTCH SPRINGS, 3 PCS. 4.95 19001 87001...
Need help?
Do you have a question about the Hyper7TQ Sport and is the answer not in the manual?
Questions and answers