Advertisement
MOUNTING
I.
THE REMOTE TEMPERATURE/HUMIDITY SENSOR
The remote temperature/humidity sensor can be mounted in several ways:
• With the use of screws
• Using adhesive tape
• Using nylon straps
A. MOUNTING WITH SCREWS
1) Remove the mounting bracket from the remote
2) Place the mounting bracket over the desired location.
3) Through the two screw holes of the bracket, mark the mounting
4) Screw mounting bracket onto the mounting surface. Ensure that the screws are tight
5) Insert the remote temperature/humidity sensor into the bracket.
B. MOUNTING WITH ADHESIVE TAPE
1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the
2) Remove the protective strip from one side of the tape.
3) Adhere the tape to the designated area on the back of the mounting bracket.
4) Remove the protective strip from the other side of the tape.
5) Position the remote temperature/humidity sensor in the desired location, ensuring that the
C. MOUNTING WITH NYLON STRAPS
1) Remove the mounting bracket from the remote temperature/humidity
2) Place two nylon straps through the slots on the mounting bracket.
3) Place the remote temperature/humidity sensor in your desired
4) Fasten the two nylon straps securely around the mounting location.
MAINTENANCE AND CARE INSTRUCTIONS
•
Extreme temperatures, vibration, and shock should be avoided to prevent damage to the
units.
•
Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the
displays and casings.
•
Do not submerge in water.
•
Immediately remove all low powered batteries to avoid leakage and damage.
•
Opening the casings invalidates the warranty. Do not try to repair the unit. Contact La Crosse Technology for
repairs.
temperature/humidity sensor.
surface with a pencil.
against the bracket.
mounting surface to ensure a secure hold. The mounting surface should be smooth and
flat.
indoor weather station can receive the signal.
sensor.
mounting location.
3
Advertisement
