Lionel Goofy & Pete Jumping Boxcar Owner's Manual
  1. Manuals
  2. Brands
  3. Lionel Manuals
  4. Toy
  5. Goofy & Pete Jumping Boxcar
  6. Owner's manual
Lionel Goofy & Pete Jumping Boxcar Owner's Manual

Lionel Goofy & Pete Jumping Boxcar Owner's Manual

Lionel goofy & pete jumping boxcar
Hide thumbs

Advertisement

Table of Contents

73-6782-250
12/04
Lionel
Goofy & Pete Jumping
Boxcar
Owner's Manual
© Disney

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Goofy & Pete Jumping Boxcar and is the answer not in the manual?

Questions and answers

Related Manuals for Lionel Goofy & Pete Jumping Boxcar

Summary of Contents for Lionel Goofy & Pete Jumping Boxcar

  • Page 1 73-6782-250 12/04 Lionel Goofy & Pete Jumping Boxcar Owner’s Manual © Disney...
  • Page 2 Installing the trigger with the FasTrack track system Installing the trigger with traditional O and O-27 gauge track Triggering the Jumping Boxcar Limited Warranty/Lionel Service The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel ®...
  • Page 3 Installing the trigger with the FasTrack track system ollow these steps as you install the trigger with the FasTrack track system. Note! We recommend that you install the trigger on a straight section of track. 1. Locate the terminal housing on the underside of the roadbed. Refer to Figure 1. Terminal housing Figure 1.
  • Page 4 Installing the trigger with the FasTrack track system (continued) 2. As illustrated in Figure 2, slide the L-shaped brackets on the trigger onto the terminal housing. Trigger position L-shaped brackets Terminal housing Figure 2. Brackets slide onto the terminal housing...
  • Page 5 Installing the trigger with the FasTrack track system (continued) 3. Slide the trigger toward the roadbed. Refer to Figure 3. Trigger is in position near the roadbed Figure 3. Trigger position...
  • Page 6 Installing the trigger with traditional O and O-27 gauge track ollow these steps as you install the trigger with O and O-27 gauge track. Refer to Figure 4. 1. Position the trigger’s stamped metal base underneath the track. 2. Snap the two tabs onto the inside edge of the outer rails. Be sure that the L-shaped bracket does not touch the center rail to prevent a short Note! circuit.
  • Page 7 Triggering the Jumping Car Follow these steps and refer to Figure 5 to operate the Jumping Car. 1. Open both doors. 2. Set the jumping mechanism by gently pulling Goofy out of the boxcar until the arm locks into the bottom portion of the guide inside the car. 3.

  • Page 8: Warranty Information

    Lionel L.L.C. or an authorized Lionel L.L.C. Service Center, together with proof of original purchase will, at the option of Lionel L.L.C., be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a replacement is not available, a refund of the original purchase price will be granted.

Table of Contents