Panasonic KX-TG2511CX Operating Instructions Manual page 38

TG2511_2521CX(e-e).book Page 38 Thursday, March 11, 2010 10:34 AM
Useful Information
Liquid damage
Problem
Liquid or other form of moisture
has entered the handset/base
unit.
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up the drying
process.
Registering a handset to the base unit
1
Handset:
{j/OK}
2
{V}/{^}: "Handset Setup" i {j/OK}
3
{V}/{^}: "Register H.set" i {j/OK}
4
Base unit:
Press and hold {x} for about 5 seconds. (No registration tone)
L If all registered handsets start ringing, press the same button to stop. Then
repeat this step. (KX-TG2512)
L The next step must be completed within 90 seconds.
5
Handset:
Wait until "Enter Base PIN" is displayed. i Enter the base unit PIN (default:
"0000"). i {j/OK}
L If you forget your PIN, contact an authorised service centre.
L When the handset has been registered successfully, w stops flashing.
Note:
L If the registration fails, try to deregister the handset and then re-register it again.
Press {j/OK}. i {V}/{^}: "Base Unit Setup" i {j/OK} i {3}{3}{5}
i {j/OK} i Select the handset(s) you want to cancel by pressing the desired
handset number. i {j/OK} i {V}/{^}: "Yes" i {j/OK} i Repeat from
step 1.
Changing the base unit PIN (Personal Identification Number)
Important:
L If you change the PIN, please make note of your new PIN. The unit will not reveal
the PIN to you. If you forget your PIN, contact an authorised service centre.
38
Cause/solution
L Disconnect the AC adaptor and telephone line
cord from the base unit. Remove the batteries
from the handset and leave to dry for at least
3 days. After the handset/base unit are
completely dry, reconnect the AC adaptor and
telephone line cord. Insert the batteries and
charge fully before use. If the unit does not
work properly, contact an authorised service
centre.