Panasonic KX-TG2511CX Operating Instructions Manual page 35

TG2511_2521CX(e-e).book Page 35 Thursday, March 11, 2010 10:34 AM
Making/answering calls, intercom
Problem
w is flashing.
Noise is heard, sound cuts in
and out.
The handset does not ring.
I cannot make a call.
*1 KX-TG2512
*2 KX-TG2521
Useful Information
Cause/solution
L The handset is too far from the base unit.
Move closer.
L The base unit's AC adaptor is not properly
connected. Reconnect AC adaptor to the
base unit.
L The handset is not registered to the base unit.
Register it (page 38).
L Activating one touch eco mode reduces the
range of the base unit in standby mode. If
required, turn eco mode off (page 12).
L You are using the handset or base unit in an
area with high electrical interference. Re-
position the base unit and use the handset
away from sources of interference.
L Move closer to the base unit.
L If you use a DSL/ADSL service, we
recommend connecting a DSL/ADSL filter
between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for
details.
L Unplug the base unit's AC adaptor to reset the
unit and turn off the handset. Reconnect the
adaptor, turn on the handset and try again.
L The ringer volume is turned off. Adjust ringer
volume (page 18).
L The dialling mode may be set incorrectly.
Change the setting (page 11).
L The handset is too far from the base unit.
Move closer and try again.
L Another unit is in use. Wait and try again
*1
later.
L Answering system is being used.
try again later.
*2
Wait and
35