Assembly And Adjustment Procedures Of Mechanism; Confirmation Of Alignment Condition - Panasonic AG-7350 Series Service Manual

4-4. ASSEMBLY AND ADJUSTMENT PROCEDURES OF MECHANISM
The mechanism of this model is mostly engaged to the System Control Circuit, through the mode select switch.
Therefore the relation between the mode select switch and the cam gear decides all further mechanical movement of the
mechanical parts such as levers, gears, rollers and so on.
If these parts are not fixed properly, the unit will be unloaded or compulsorily stopped.
And it will result being damaged at any mechanical or electrical parts.
The overall mechanical condition (alignment) of bottom and top view are shown in Figure M45 and Figure M46. This
mechanical adjustment is performed in the STOP mode.
4-4-1. CONFIRMATION OF ALIGNMENT
CONDITION
1. Remove the Loading Belt.
2. Unscrew 4 screws and remove the Gear Base
Unit. (Figure M45)
3. Turn the Center Gear to counter-clockwise until 2 big
holes of Center Gear align with 2 big holes of Retainer
Gear and Ring Gear and Chassis as shown in Figure
M47.
4. Identification hole on the Mode Select Switch at 6
oclock position and aligned with small hole on Pinch
Cam as shown in Figure M46.
5. PS Arm Is completely loading position and the inclined
Base (S) and (T) are completely unloading position.
Screws
Gear Base Unit
Figure M45
Center Gear
Through Holes
Detent
Arm---.111~
Sub Cam Gear
6. Small hole on Sub Cam Gear should align with small
hole on the Connection Gear and rectangular mark on
the Connection Gear should be at a 3 oclock position.
7. Pressure Roller Unit is UP position.
Sub Cam Gear
~---
I
I
\
/
I
\
\
/
'
......
_-,.,....
Connection
Gear
Figure M46 Top View of Overall IQ-Mechanical Condition
Sector Gear
Loading Gear (T)
Loading Cam Gear
Loading Gear (S)
Retainer Gear
Ring Gear
Figure M47 Bottom View of Overall Mechanical Condition
4-15
....
z
w
:E
....
en
:::)
....,
c
<C
......
<C
(.)
z
<C
:I:
(.)
w
:E