Panasonic AG-7350 Series Service Manual page 57

4-4-11. ASSEMBLY PROCEDURES OF
GEAR BASE UNIT
1. Install the Gear Base Unit and screw 4 screws as shown
in Figure M58.
Screws
Gear Base Unit
Figure M58
<<NOTE>>
The Gear Base Unit has 2 gears and wormshaft. There is no
adjustment for these gears.
4-4-12. REINSTALLATION OF GASSETT
COMPARTMENT
When you reinstall the cassette compartment, the position
adjustment of mechanism is necessary for correct opera-
tion, as follows.
A Confirmation of STOP Alignment Condition
1. Turn the Wormshaft counter-clockwise or clockwise
until mechanism is placed into the Alignment Condition
as following conditions.
a) Identification hole on the Mode Select Switch at 6
oclock position and aligned with small hole on Pinch
Cam. (Figure M57)
b) P5 Arm is completely loading position and the In-
clined Base (S) and (T) are completely unloading
position.
c) Small hole on Sub Cam Gear should align with small
hole on the Connection Gear (Figure M55) and rec-
tangular mark on the Connection Gear should be at a
3 oclock position.
d) Pressure Roller Unit is UP position.
B.
Confirmation of Cassette Compartment
1 . Confirm that the Cassette Compartment Is aligned prop-
erly. In the EJECT position (Cassette Holder up and ad-
vanced to the front) the two V-shaped marks on the
slide switch should align. The slide switch is located on
the right side of the Cassette Assembly towards the rear
as shown in Figure M59.
Eject mark
Photo Tr <T> C.B.A.
<Cassette Switch>
Figure M59
2. Remove 3 screws (A) as shownin Figure M60.
3. Take the top plate out.
4. Take the cassette Holder unit out as shown in Figure
M61.
Top Plate Screws (A)
Figure M60
Cassette Holder unit
Figure M61 Removal of cassette holder unit
4-19
t-
z
w
::E
t-
CJ)
::::)
...,
c
<(
...J
<(
0
z
<(
J:
0
w
::E