Timer Recording (Ag-7350 Only) - Panasonic AG-7350 Series Service Manual

..A.
I
00
1-7. Timer Recording (AG-7350 only)
Model AG-7150 is not equipped with recording function.
1 .
3
Turn on the unit and insert a
video cassette.
• Make sure that the erasure prevention tab on the video cas-
sette is intact.
2
OPERATING INSTRUCTIONS
Connections
5.
To Audio Output (CH1)
r--------------------------~•:1
To Audio Output (CH2)
.---------------------___.:.-~_;_.,."
,------------------T_o_V_id_e_o_o_u~tp_u_t _ _ _ _
AC Power
Cord
To AC Outlet
VIDEO IN
~=====0 [C£JI@]
ACPow?r
AC Power Cord Clock Timer Cord
When the preset time comes
At the preset time ON time, the unit will be turned on automatically to start TIMER recording. At the preset
OFF time, the unit will be turned off, but the tape will remain loaded on the cylinder inside the unit.
When the power is resumed, the unit will go into the stop mode and then into the TIMER recording mode.
_6.
Press the STOP Button to stop
TIMER recording halfway.
STOP
~
2. Set the EXT TIMER Selector to
"REC".
p~;;n
l
REC(§J
EXT TIMER
------Notes
3. Adjust the audio recording level.
(Refer page 14.)
4. Set the timer.
[1] Turn on the timer.
[2] Set the timer to the desired ON and OFF time.
• It may take about 1 minute to load the tape on the cylinder inside the unit when the preset ON time comes.
Therefore, set the preset ON time at least about 1 minute ahead of the actual start time.
• It is best to set the OFF time so that the unit is turned off about 10 minutes after the tape reaches its end. This
will prevent the tape from damage.
If, for example, NV-E180 tape is used for TIMER recording, the recording time should be preset for about 190
minutes.
• Refer to the operating instructions of the timer you are using for details.
• When the tape reaches its end, the unit will go into the mode set in the ON-SCREEN menu (TAPE END MENU).
• If the power is turned off while the tape is moving during TIMER recording, the tape will remain loaded on the
cylinder inside the unit. When the power is resumed, the unit will unload the tape from the cylinder. After a while,
the unit goes into the stop mode and then the TIMER recording mode.