Mercedes-Benz S-Class Coupe 2015 Operator's Manual page 341

Do not remove any foreign objects which
X
have penetrated the tire, e.g. screws or
nails.
Remove the tire sealant bottle, the accom-
X
panying TIREFIT sticker and the tire infla-
tion compressor from the stowage well
underneath the trunk floor (
Affix part : of the TIREFIT sticker within
X
the driver's field of vision.
Affix part ; of the TIREFIT sticker near the
X
valve on the wheel with the defective tire.
Pull plug ? with the cable and hose A out
X
of the housing.
Screw hose A onto flange B of tire seal-
X
ant bottle :.
Place tire sealant bottle : head down-
X
wards into recess ; of the tire inflation
compressor.
Remove the cap from valve C on the faulty
X
tire.
Screw filler hose D onto valve C.
X
Insert connector ? into a 12 V socket
X
(
Y
Turn the SmartKey to position 1 in the igni-
X
tion lock (
Press on/off switch = on the tire inflation
X
compressor to I.
page 336).
Y
The tire inflation compressor is switched
on. The tire is inflated.
i
The pressure can briefly rise to approx-
imately 500 kPa (5 bar/73 psi).
Do not switch off the tire inflation com-
pressor during this phase.
Allow the tire inflation compressor to run
X
for five minutes. The tire should then have
attained a pressure of at least 180 kPa
(1.8 bar/26 psi).
If a pressure of 180 kPa (1.8 bar/26 psi) has
been attained after five minutes, see "Tire
pressure reached" (
If a tire pressure of 180 kPa (1.8 bar/26 psi)
has not been attained after five minutes, see
"Tire pressure not reached" (
i
can then be removed like a layer of film.
If your clothes are soiled with tire sealant,
have them cleaned with perchloroethylene
at a dry cleaner as soon as possible.
Tire pressure not reached
If a pressure of 180 kPa (1.8 bar/26 psi) has
not been attained after five minutes:
Switch off the tire inflation compressor.
X
Unscrew the filler hose from the valve of
X
the faulty tire.
Very slowly drive forwards or reverse
X
approximately 30 ft (10 m).
Pump up the tire again.
X
After a maximum of five minutes the tire
pressure must be at least 180 kPa (1.8 bar/
26 psi).
page 301) in your vehicle.
page 147).
Y
First, tire sealant is pumped into the tire.
page 340).
Y
If tire sealant leaks out, allow it to dry. It
Flat tire
339
page 339).
Y
Z