Assembly - RIDGID R5011 Operator's Manual

ASSEMBLY

UNPACkING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing
or damaged. Use of a product that is not properly
and completely assembled could result in serious
personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACkING LIST
Hammer Drill
Depth Stop Rod
Auxiliary Handle
Tool Bag
Chuck Key
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate
this tool until the parts are replaced. Use of this
product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modification is misuse
and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly
is complete. Failure to comply could result in
accidental starting and possible serious personal
injury.
INSTALLING AUXILIARY HANDLE ASSEMBLY
See Figure 2, page 14.
An auxiliary handle is packed with the drill for ease of opera-
tion and to help prevent loss of control.
 Open the clamping ring by turning the handle counter-
clockwise.
 Slide the ring of the auxiliary handle onto the spindle collar
of the drill.
 Tighten the auxiliary handle at the desired angle by turning
the handle clockwise.
NOTE: For convenience the screw has been trapped inside
the auxiliary handle.
To prevent thread damage and possible loss of control, the
auxiliary handle should be checked periodically for tightness.
Do not operate the drill with the handle loose.
INSTALLING THE DEPTH STOP ROD
See Figure 3, page 14.
Follow these steps to install the depth stop rod:
 Depress the depth stop rod adjustment button.
 Insert the depth stop rod as shown in figure 3.
 Release the depth stop rod adjustment button.
8 - English