Canon EOC-1DX Instruction Manual page 691

Erasing Unwanted Parts of an Image (Copy Stamp Function)
You can correct an image by pasting a section copied from another part
of the image to an unwanted part of the image.
1 Follow steps 1 to 3 in "Manually Erasing Dust (Repair
Function)" .
(p.116)
2 Specify the section to be copied.
Click on the section that is to be the copy source while holding

down the <option> key.
To change the section that is to be the copy source, perform the

operation above again.
To fix the position of the copy source, checkmark [Fix Copy

Source position].
3 Correct the image.
Click or drag on the section you want to correct on the image. [

in the window indicates the copy source and [ ] indicates the
copy destination.
The copied image is pasted in the position to which it was

dragged.
For [Pen type], you can select from [Brush] (the pasted image's

borders simulate a brush) and [Pencil] (the pasted image's
borders are sharp).
4
Click the [OK] button to return to the main window.
The [ ] mark (p.126) is displayed on a corrected image.

Compositing and High Dynamic Range
You can composite images also using JPEG and TIFF images in the
same way as RAW images as described below.
Compositing Images

Creating HDR (High Dynamic Range) Images

Starting Up Map Utility
You can start up Map Utility using the procedure below.
Starting Up Map Utility

+
]
(p.78)
(p.81)
(p.84)
Introduction
Contents at
a Glance
1
Basic
Operation
2
Advanced
Operation
Advanced 3
Image Editing
and Printing
Processing 4
Large Numbers
of Images
Editing
5
JPEG/TIFF
Images
Reference
Index
118