DETAILED SET-UP GUIDE FOR THE WIRELESS RAIN GAUGE I) Battery Installation Note: Batteries will fit tightly. To avoid start-up problems make sure that the batteries do not spring free. A) Remote Rainfall Sensor 1. Remove the flat-head screw and battery cover located on the underside of the base.
3. Place the base over a desired mounting surface. 4. With a pencil mark the mounting surface through the cylindrical holes. 5. Where marked start the screws. 6. Place the base over mounting surface. 7. Install screws through the cylindrical holes and into the started holes on the mounting surface.
La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd.
Page 6
This handbook may contain mistakes and printing errors. The information in this handbook is regularly checked and corrections made in the next issue. We accept no liability for technical mistakes or printing errors, or their consequences. All trademarks and patents are acknowledged. FCC ID: OMO-01TX (transmitter) THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.