Time Remaining; Selecting Options - Asko D5524XXLFI Operating Instructions Manual

Daily wash
A program suitable for day-to-day dishwashing. This program can
also clean dried leftovers, but is not intended for burnt food, such
as on oven dishes.
Quick wash
This program is used for glasses and porcelain that is lightly soiled,
such as coffee cups.
Super Quick wash
Short program lasting about 15 minutes with acceptable results
for very lightly soiled dishes.
Delicate wash
If the dishes are only lightly soiled, you can select Delicate wash.
This program is intended for glasses and porcelain that have just
been used and as such do not require such a powerful program.
This program can be used for fragile dishes. Select Short dry if you
want to be especially cautious. See also the section Fragile dishes
in the chapter Loading the dishwasher.
Eco wash
Use when you want to save energy. For normally soiled dishes.
Rinse & Dry
This program consists of a rinse with heating and drying. This is a
suitable program if, for example, you plan to make jam and want
to rinse and heat clean glass jars.
Rinse & Hold
Use to rinse dishes while you wait for the dishwasher to become
fully loaded.

SELECTING OPTIONS

To select an option, press one of the option buttons. The field
under the button lights when the option is activated. The available
options depend on the selected program. Once you have started
the program, the options you selected are saved for the next time
you use the same program.
High temperature
Activate this option for improved dishwashing results. The machine
then uses a higher temperature for the main wash.
If you want to use the lower temperature, press again so that the
field under the button turns off.
You can vary the temperature as shown below:
Heavy wash:
Normal wash:
Daily wash:
Quick wash:
Super Quick wash:
Delicate wash:
Eco wash:
Long dry
A higher temperature in the final rinse and a longer drying phase
improves the drying result if you activate the Long dry option. This
causes a slight increase in energy consumption. This option can be
used with all programs except Rinse & Dry, and Rinse & Hold.
If you want a program with Short dry, press again so that the field
under the button turns off.
START THE DISHWASHER
Press and hold Start/Stop until the display shows
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last program run.

TIME REMAINING

Once you have selected a program and options, the display
indicates how long the program took the last time it was used. The
remaining time is updated after the water for the final rinse has
been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature, and other factors.
NOTE!
During the first run of each program, the remaining time
displayed can be slightly misleading, as the dishwasher is estimating
the time. When you run the program a second time, the
dishwasher will calculate the remaining time based on the
previous duration of the program.
STOPPING OR CHANGING A PROGRAM
If you want to change programs after starting the dishwasher, open
the door then press and hold Start/Stop for three seconds. Add
more detergent if the lid of the detergent dispenser has opened.
Then choose a new program, press Start/Stop, and close the door.
Customer Care Center 1-800-898-1879
www.askousa.com
140 °F (60 °C) / 160 °F (70 °C)
130 °F (55 °C) / 150 °F (65 °C)
140 °F (60 °C)/150 °F (65 °C)
85 °F (30 °C) / 140 °F (60 °C)
85 °F (30 °C) / 140 °F (60 °C)
105 °F (40 °C) / 120 °F (50 °C)
120 °F (50 °C) / 140 °F (60 °C)
(the door
8