Drive Chain - HYOSUNG WOW 50 Service Manual

DRIVE CHAIN

NOTE :
Inspect and lubricate Every month.
Visually check the drive chain for the possible defects listed
below.
1. Loosen pins
2. Damaged rollers
3. Dry or rusted links
4. Kinked or binding links
5. Excessive wear
If any defects are found, the drive chain must be
replaced.
◉ ◉ LUBRICATING THE DRIVE CHAIN
Dirt hastens wear of drive chain and sprockets.
Lubricate the drive chain with chain lube or motor oil fre-
quently. Every 1 month or more frequently, wash the
chain clean in a pool of solvent and lubricate it with
chain lube or motor oil. In a dusty area, this service
should be given at shorter intervals.
CAUTION
When refitting the drive chain, be sure to install
the chain joint clip as shown : the slit end faces
counter to turning direction.
◉ DRIVE CHAIN REPLACEMENT
The drive chain is checked when its slack (between two
sprockets) is within 5~15 mm (0.197~0.591 in) range.
Drive chain slack
If the drive chain slack exceeds the specification, the
chain must be replaced.
5 ~ 15 mm
(0.197 ~ 0.591 in)
PERIODIC MAINTENANCE 2-10
5~15 mm
(0.197~0.591 in)