Table of Contents
Advertisement
10
Symptom
The edge of the copy is dirty.
The image is not aligned
properly on the paper.
10-2
Possible Cause
Either the document pad or
the document transfer belt is
dirty.
The selected copy paper size
is larger than the document
(with Zoom set to "× 1.000").
The orientation of the
document is different from
the orientation of the copy
(with Zoom set to "× 1.000").
The copy was reduced to a
size smaller than the copy
paper (a Custom Zoom
setting was selected).
The document is not
positioned correctly.
The document is not
positioned correctly in the
duplexing document feeder.
The original glass is dirty
(while using the duplexing
document feeder).
The document guides are not
positioned along the edges
of the paper.
Curled paper was loaded into
the paper drawer.
Troubleshooting
Remedy
Clean the document pad or
the document transfer belt
with a soft cloth dampened
with mild detergent. Refer to
p. 11-9.
Select a copy paper size that
is the same as the size of the
document. Refer to p. 5-4.
Otherwise, set Zoom to "Auto
Size" to enlarge the copy to
the selected paper size.
Refer to p. 5-14.
Select a copy paper size that
is the same as the size of the
document. Otherwise, select
a copy orientation that is the
same as the orientation of
the document.
Select a zoom ratio that
adjusts the document size to
the selected paper size.
Refer to p. 5-15. Otherwise,
set Zoom to "Auto Size" to
reduce the copy to the
selected paper size. Refer to
p. 5-14.
Correctly position the
document against the
document width scale. Refer
to p. 4-11. Correctly load the
document into the duplexing
document feeder, and then
slide the document guides
against it. Refer to p. 4-4.
Open the duplexing
document feeder, and
correctly position the
document against the
document width scale. Refer
to p. 4-11.
Wipe the glass with a soft dry
cloth. Refer to p. 11-8.
Slide the document guides
against the edges of the
paper.
Flatten the paper before
loading it.
KM-C1530
Advertisement
Table of Contents
