LG LSXS22423 Series Owner's Manual page 15

Back of refrigerator
Tubing Clamp
1
¼" (6,35 mm)
Compression
Nut
2
Ferrule
(sleeve)
Figure 1
Fasten the tubing into the tubing clamp attached to the
back of the refrigerator.
First, loosen the screw fastening the clamp. Next, insert
the tubing in the groove. Finally, re-fasten the screw.
10. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so
that it does not vibrate against
the back of the refrigerator or
against the wall. Push the
refrigerator back to the wall.
11. START THE ICEMAKER
Set the icemaker power switch to the ON (I) position.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below. It
will then begin operation automatically if the icemaker
power switch is in the ON (I) position.
REFRIGERATOR INSTALLATION
¼" (6,35 mm) Tubing
Part A
Refrigerator
Connection
13