Booster - Britax Maxi Rider AHR Instructions For Installation Manual

HOW TO USE
C. The restraint is now ready for use
as a child booster, ensure the upper
anchorage strap is still engaged into
the anchor fitting (as shown right) and
tighten if necessary. Do not overtighten
causing the seat to lift.
Always attach hook and remove slack.
D. Sit the child on the seat.
Red seat belt path labels
BOOSTER SEATBELT PATH
36 Instructions for Installation & Use - Series No. 8000/B/2010
Car's Anchor
Attachment Clip
Fitting
Fully press Adjuster Button
(A) while pulling Upper
Anchorage Strap (B) to
A
lengthen.
B
Storage
Band
C
Pull Adjustment Strap
to remove slack
D
E. Position the lap-sash belt over the child ensuring
the lap portion is positioned into the lap recess area
under the armrest and on the child's thighs. The
seat belt should follow the red Seat Belt path labels
marked -BOOSTER SEATBELT PATH
Fit the SLIDEGUARD™ clip to the lap belt as shown
below. The SLIDEGUARD™ clip must be used at
all times in Booster mode, to position the lap belt
on the child's thighs and prevent your child from
submarining in the event of an impact. If the lap belt
is not on the child's thighs then shorten the length
of the crotch strap, see page 34.
F. Engage seat belt buckle and tongue ensuring there
are no twists in the belt. If the seat belt buckle is
adjustable, adjust the buckle as low as possible
away from the child.
IMPORTANT:
A SASH BELT UNDER THE ARM OR
BEHIND THE BACK IS DANGEROUS.
NOTE: Some vehicle seats have more rearward
slope than others. Use a rolled up towel or
padding under the seat for contoured vehicle
seats to prevent excessive recline.
Instructions for Installation & Use - Series No. 8000/B/2010
HOW TO USE
Remove SLIDEGUARD™
converter from recess area and
engage into harness buckle.
Click
Hook the Lap Belt
SLIDEGUARD™ clip
Lap part of seat
over the lap belt with
belt in recess area
the Red button (of the
(under armrests).
buckle) facing forward.
E
Rolled up towel
or padding
37