Seat Belt - Britax Maxi Rider AHR Instructions For Installation Manual

HOW TO INSTALL
F. To lengthen the Upper Anchorage
Strap, fully press Adjuster Button (A)
while pulling Upper Anchorage Strap
(B) to slacken as shown right.
G. Connect the Attachment Clip to the
Anchor Fitting in the car making
sure to remove as many twists as
possible.
H. Pull Upper Anchorage Adjustment Strap (c) to remove any slack but do not tighten so much that
the restraint lifts off the car seat. Fold up excess strap and use storage strap to neatly store excess
strap behind seat.
Always attach hook and remove slack.
IMPORTANT :
Always ensure that the car seat belt and upper anchorage strap are firmly restraining the restraint on
the vehicle seat.
Make sure Cup Holders (If fitted) do not interfere with closure of the car door.
22 Instructions for Installation & Use - Series No. 8000/B/2010
F
A
B
Storage
Band
C
Pull Adjustment Strap
to remove slack
F H
Car's Anchor
Attachment Clip
Fitting
TO REMOVE TODDLER FROM RESTRAINT
A. Press red button on Harness Buckle then both Harness
Tongues will be released. Move each shoulder strap to
the toddler's side, then remove the toddler.
TO REMOVE RESTRAINT FROM
VEHICLE
A. Disengage seat belt tongue from buckle and
remove from restraint.
B. Fully press Upper Anchorage Strap Adjuster
Button (A) while pulling Upper Anchorage Strap
(B) to slacken as shown right. In some vehicles
loosening of the Upper Anchorage Strap may
be difficult. If so, try pushing the restraint
against the vehicle seat back or slightly lifting
the restraint to release the tension.
C. Disengage Attachment Clip from the Car's
Anchor Fitting. The child restraint is now
disconnected.
Instructions for Installation & Use - Series No. 8000/B/2010
HOW TO INSTALL
Fully press Adjuster Button
(A) while pulling Upper
Anchorage Strap (B) to
lengthen. A
B
Storage
Band
C
Pull Adjustment Strap
to remove slack
Roll up excess
strap and store with
the storage band.
23