Kyocera FS-1350DN Operation Manual page 151

>>Auto Panel
Reset ? On
>>Panel Reset
Timer
>>Auto Sleep
? On
7-54
For setting the time until the panel is reset, refer to the next section
Panel Reset Timer (Setting the panel reset timer).
1
Press
2
Press
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
Panel Reset Timer (Setting the panel reset timer)
When Auto Panel Reset is set to On, this sets the time until the panel is
automatically reset after the user stops using the panel. The default time
is 90 seconds.
1
Press
2
Press
3
Press [OK]. The message display shows a blinking cursor (_).
090sec.
4
Press
cursor and set the desired time. The time must be set between 005
and 495 seconds, in 5-second increments. Use
the cursor right and left.
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
Auto Sleep (Setting the sleep timer)
The printer has a sleep timer that is used to conserve power when the
printer is not printing, processing, or receiving data. The default setting is
On.
1
Press
2
Press
3
To turn off the sleep timer, press [OK]. A blinking question mark (?)
appears.
4
Select On or Off using
5
Press [OK]. The sleep timer is turned off.
6
Press [MENU]. The display returns to Ready.
while >Timer > is displayed.
repeatedly until >>Auto Panel Reset appears.
or
or .
while >Timer > is displayed.
repeatedly until >>Panel Reset Timer appears.
or
or to increase or decrease the value at the blinking
while >Timer > is displayed.
repeatedly until >>Auto Sleep appears.
or
or .
and to move
Using the Operation Panel