Starting the computer by password
If you have already registered a password, please enter the password
manually to start the computer:
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 3,
following message appears:
At this point, the hotkeys FN + F1 to F9 do not work. They will function
after you enter the password.
2. Enter the Password.
3. Press Enter.
If you enter the password incorrectly three consecutive times, the
computer shuts down. You must turn on the computer again and re-enter
Boot Priority Options
This option sets the priority for booting the computer.
To change the boot drive, follow the steps below.
1. Hold down F12 and boot the computer.
2. Use the up/down cursor keys to select boot device you want and press
If a supervisor password is set, the menu above does not appear when
you use the user password to start the computer.
If you press a key other than one of those above or if the selected
device is not installed, the system will boot according to the current
setting in BIOS Setup Menu.
Legacy USB Support
Use this option to enable or disable USB Legacy Emulation. If your
operating system does not support USB, you can still use a USB mouse
and keyboard by setting the USB Legacy Emulation item to enabled.
Enables USB Legacy Emulation. (Default)
Disables USB Legacy Emulation.
BIOS Setup and Passwords