Starting The Engine - Toro TimeCutter MX5060 Operator's Manual

tank allows the fuel to expand. Overfilling may result in
fuel leakage or damage to the engine or emission system.
1. Clean around the fuel tank cap and remove the cap.
Note: You can use the fuel window to verify the
presence of gasoline before filling the tank (Figure 10).
2. Slowly add regular, unleaded gasoline until the fuel
reaches the base of the filler neck (Figure 10).
6 5
Figure 10
1. Fuel tank cap
2. Fill opening
3. Filler neck
4
G014895
3
1. Fill opening
2. Base of filler neck, DO
NOT FILL PAST HERE
3. Install the fuel tank cap securely and tighten until it
"clicks". Wipe up any gasoline that may have spilled.

Starting the Engine

1. Sit down on the seat and move the motion controls
outward to the park position.
2. Move the throttle to the fast position (Figure 12).
3. Disengage the blades by moving the blade control
switch to Off (Figure 12).
1
G014474
4. Base of filler neck, DO
NOT FILL PAST HERE
5. Fuel window
6. Fuel tank
1
Figure 11
3. Fuel
4. Empty space for fuel
expansion.
2
3
4
1. Throttle
4. Pull up on the Choke control before starting a cold
engine (Figure 13).
Note: A warm or hot engine may not require choking.
2
1. Control panel
2. Throttle
3. Fast
5. Turn the ignition key to Start to energize the starter.
When the engine starts, release the key (Figure 14).
Important: Do not engage the starter for more
than 10 seconds at a time. If the engine fails to
start, allow a 60 second cool-down period between
17
Figure 12
2. Blade control switch—Off
position
g017699
Figure 13
4. Slow
5. Choke control