Product Overview; Controls; Ignition Switch; Throttle Control - Toro TimeCutter MX5060 Operator's Manual

Product Overview

5
4
3
2
1
13
1. Deflector
2. Rear drive wheel
3. Height of cut lever
4. Control panel

Controls

Become familiar with all of the controls in Figure 4 and
Figure 5 before you start the engine and operate the machine.
Control Panel
1. Throttle

2. Ignition switch

6
5. Motion control levers
6. Operator seat
7. Foot assist lever (certain
models only)
8. Gas tank cap
Figure 5
3. Blade control switch
(power take-off)
4. Choke
5
14
7
11
12
Figure 4
9. Engine
10. Engine guard
11. Mower deck
12. Front caster wheel
Ignition Switch
The ignition switch has three positions, Off, Run and Start.
The key will turn to Start and move back to Run upon release.
Turning the key to the Off position will stop the engine;
however, always remove the key when leaving the machine
to prevent someone from accidentally starting the engine
(Figure 5).

Throttle Control

The throttle controls the engine speed and it has a continuous
variable setting from Slow to Fast (Figure 5).

Choke Control

Pull up on the Choke control until it stops to choke the
engine (Figure 5). Push down on the Choke control for
normal engine operation
Blade Control Switch (Power Take-Off)
The blade control switch, represented by a power take-off
(PTO) symbol, engages and disengages power to the mower
blades (Figure 5).
13
8 15
9
13. Anti-scalp roller
14. Smart Speed™ lever
15. Hydraulic reservoir
10
G020177