Lcd Module Reassembly Procedure; Replacing The Antennas - Acer Packard Bell dot M Series Service Manual

LCD Module Reassembly Procedure

Replacing the Antennas

1. Remove the protective covering on the left and right Antenna pads. Place the Antenna pads in the LCD Module
and press down to secure the adhesive in place.
IMPORTANT: be sure the cables pass behind the shielding material as shown.
2. Run the left side cable down the side and along the lower edge of the LCD Module using all the available cable
clips.
3. Run the right side cable down the side of the LCD Module using all the available cable clips. Be sure the
cables pass behind the shielding material as shown.
57