Error Messages - Nikon D3000 User Manual

Error Messages
This section lists the indicators and error messages that appear in the viewfinder and
monitor.
• Warning Icons
A flashing
~
in the monitor or I1l in the viewfinder indicates that a warning or error message
can be displayed in the monitor by pressing the
?
U~~)
button.
Solution
'F==/I1J'~
Attach non-IX NIKKOR lens. . .
: (blinks) :. If non-CPU lens is attached, select mode M.
. ~.... .......•..._ _•........_.1---.--. .•...•.••..__._.._.•..•.•.•..•..•_ _ _._ .••..•....•....._ _ ~~ ..•..__ __ _..••._ _ ..__.....•..•••••..•..•......•_...•.• ~ ..•.....•._...•.... .__ _
Lens not attached.
Indicator
. . . .
······-~···Monitor~·--····_·
TVieWflnder- 1
.- . .........!.-_.._.
._-1-_. _
Lock lens aperture ring' ,
at minimum aperture
FE E
i
Set lens aperture ring to minimum aperture (largest
(blinks) if-number).
(largest f/-number).
.............
.
,
~
.
Shutter release disabled.
Recharge battery.
.
...
_ - - - ; : -
This battery can not be used.
Choose battery designated
for use in this camera.
.......
_ _ .....•..................•.. _
..
_--_.-
_
_
_ .
Initialization error. Turn
camera off and then on
again.
c::.
(blinks)
Turn camera off and recharge or replace battery.
I
Use Nikon-approved battery (EN-EL9a).
'Turn camera off, remove and replace battery, and then
,turn camera on again.
Battery level is low. :
Complete operation and turn
j
camera off immediately.
I
End cleaning and turn camera off and recharge or replace
:battery.
Clock not set.
No memory card.
This memory card cannot be i
!
[[HR)
used. Card may be damaged. i
(blinks)
Insert another card. :
Set camera
[_ E_)
Turn camera off and confirm that card is correctly
,inserted.
,
Memory card isioClcecL;"
[MR'Memory
ca ref
IS·
Iocked (write protected). Slide card write-
Slide lock to "write" position. i
(blinks) iprotect switch to "write" position.
- - - - _ .
'. Use approved card.
,. Format card. If problem persists, card may be
damaged. Contact Nikon-authorized service
representative.
• Error creating new folder. Delete files or insert new
memory card.
• Insert new memory card.
• Eye-Fi card is still emitting wireless signal after
Disable
has been selected for Eye-Fi upload. To terminate
wireless transmission, turn the camera off and remove
the card.
53