Maintenance Information - HAKO -Jonas 1500 V Instruction Manual

Safety Information
as to whether obligations exist in this
respect.
1.4

Maintenance information

• Operating personnel must complete
the necessary daily and weekly
maintenance work. All other mainte-
nance work must be completed at
your nearest Hako service center.
• The maintenance work and mainte-
nance intervals prescribed in the
operating manual must be adhered
to.
• Allow the engine to cool down before
starting cleaning and maintenance
work. Hot surfaces represent a risk
of burns!
• Pay attention to any rotating parts
before starting cleaning and mainte-
nance work. They represent a risk of
crushing!
• Suitable tools must be used for
cleaning and maintenance work.
• The vehicle must be inspected by a
recognized technical expert in re-
spect of operational safety, within
the terms of the applicable accident
prevention laws, at reasonable inter-
vals (we recommend at least once a
year) and following modification or
repairs.
10
• Spare parts must comply with the mi-
nimum technical requirements stipu-
lated by the manufacturer! This is
ensured by the use of original spare
parts.
• Only use the rotary brushes and side
brushes recommended by the ma-
nufacturer (refer to Technical Data).
The use of other rotary brushes and
side brushes could impair safety.
• Only use the air and oil filters recom-
mended by the manufacturer (refer
to Technical Data). The use of other
filters could impair safety.
• The vehicle must be switched off pri-
or to cleaning or servicing it or to re-
placing parts.
The ignition key must be removed.
• The sweepings container must be
cleaned regularly to prevent the ac-
cumulation of bacteria.
• The vehicle is splashproof (IPX3).
It is not permitted to clean the vehicle
with a pressure washer or steam bla-
ster.
• The engine must be switched off
when transporting the vehicle.
• If the Hako-Jonas 1500 is jacked up
with a jack, it must be properly sup-
ported.
• No persons may be on the Hako-Jo-
nas 1500 when it is jacked or raised.
• When changing wheels, the vehicle
must be additionally secured from
rolling away by placing wheel chocks
against the wheels.
Always change wheels on level, so-
lid ground, where possible.
• Do not remove or replace tires or re-
pair one on a rim. Always go to a pro-
per workshop for work on tires and
rims because they have specially
trained personnel and special safety
tools. Never loosen the screws in the
two-part rims while the wheel is still
mounted on the vehicle and there is
air in the tires. Risk of severe injury!
• Do not carry out any welding, drilling,
sawing or grinding work on frame
parts. Damaged parts may only be
replaced by specialist workshops ap-
proved by Hako.
• Only use original fuses. Using fuses
which are too powerful could dama-
ge the electrical installation and lead
to fires.
• Always disconnect the negative pole
of the battery when working on the
electrical installation.
• Never leave the batteries in a