Table of Contents
Advertisement
2
INSTALLATION
2.2 Prechecks
1. Verify that all parts have been received by checking
them against the packing list. If there are questions
regarding the shipment, notify the Re-Verber-Ray
distributor or Brant Radiant Heaters Limited at
Customer Service- 1-800-387-4778.
2. Check the CSA rating label located on the heater's
control box above the inlet gas supply connection,
to verify the model number, gas input and the gas
to be used.
3 IN./7.6cm DIA. VENT PIPE
ALTERNATE AIR INTAKE
(THROUGH ROOF)
CHAIN
SET
GLO-BAR BOX
AIR INTAKE THROUGH WALL
BR-VC INLET VENT CAP
TYPICAL INSTALLATION DRAWING
3. Locate the Clearance-To-Combustibles label
affixed to the heater's access panel/cover. Using
the heater's model numbers, as displayed on the
rating label, make sure the finished installation
will conform to the design requirements listed on
the label and the Clearance-To-Combustibles
Chart and the figures shown on page 3.
4. Heaters may discharge the combustion-by-
products directly into the heated space when the
conditions in section 2.9 Installation for Unvented
operation have been met.
ALTERNATE EXHAUST
(THROUGH ROOF)
CHAIN
SET
REFLECTOR (shown at 30 mounting angle)
Figure 2.2.1
7
EXHAUST
VENT CAP
Advertisement
Table of Contents
