Reliable Equipment REL-LP-6TN-A Operator's Manual page 8

There exists the potential for shock in using anything other
than certified nonconductive hoses and hydraulic oil with
dielectric properties, when using system components near
WARNING
energized electrical lines. Failure to recognize these conditions
could cause electrocution.
Hoses and fittings used with this tool must comply with S.A.E. J1273 which
covers recommended practice for selection, installation, and maintenance of hose
and hose assemblies. The correct hoses and fittings are available from your supplier.
WARNING: Failure to comply with these warnings could result in severe bodily injury.
UNIT/HOSE CONNECTIONS
ALWAYS DISCONNECT pump/power source and move toggle
switch to OFF before connecting or disconnecting any components.
ALWAYS DEPRESSURIZE hydraulic system, before slowly
WARNING
disconnecting this unit or any of the systems components.
ALWAYS TIGHTEN couplings completely. Loose or improperly
tightened couplings will not allow fluid to pass through the
hose creating a blockage in the supply or return line.
ALWAYS INSPECT HOSES AND CONNECTORS before
connection to tool. Replace or repair if any signs of wear,
damage, or leakage are evident. Leakage is a sign of deterioration
in component parts. Worn or leaking parts must be repaired
or replaced, or tool damage and/or severe injury could result.
ALWAYS ENSURE CONNECTORS ARE CLEAN
Care must be taken to assure the correct connection of the hoses
CAUTION
to the pressure and return (tank) ports.
Connect the return hose to the return (tank) port on the power
source, then to the return port on the tool.
Connect the pressure hose to the pressure port on the tool, then
to the "P" pressure port on the power source.
Operation with hydraulic flow reversed can cause malfunction.
Failure to fully comply can result in severe injury or death.
HOSES AND FITTINGS
HOSE INSTALLATION
8