Pre-Operation Checks - Firman ECO4000 Owner's Manual

4. PRE-OPERATION CHECKS

Remove the Generator from the Shipping Carton
1. Set the shipping carton on a solid,flat surface.
2. Remove everything from the carton except the generator.
3. Carefully cut each corner of the box from top to bottom. Fold each side flat on
the ground to provide a surface area to install the wheel kit and support leg.
Install the Wheel Kit
[CAUTION]
The wheel kit is not intended for over-the-road use.
4
2
3
1
You will need the following tools to install the wheels:
• 21mm wrench or adjustable wrench (not included)
• Socket wrench with a 13mm socket (not included)
• Pliers (not included)
1. Before adding fuel and oil, tip the generator on its side.
2. Slide the wheel bolt (1) through the wheel, the mount point on the frame,
washer(if have).
3. Press the pin(3) into the bolt (1)
4. Fasten securely with the nut (4).
5. Repeat steps 2-4 to attach the second wheel.
Install the Support Leg
1. Attach the support leg to the generator frame with cap screws and nuts.
2. Tip the generator slowly so that it rests on the wheels and support leg.
Page 12