Mobile Home Installation; Gas Installation; Optional Wall Switch Installation - Napoleon GD34-1NT Installation And Operating Instructions Manual

Natural gas/ propane gas fireplace napoleon

Hide thumbs Also See for GD34-1NT:

Installation and operating instructions manual (32 pages)

Installation and operating instructions manual (52 pages)

Installation and operating instructions manual (108 pages)

Table Of Contents

Table of Contents

This appliance is certiﬁ ed to be installed as an OEM (Original Equipment Manufacturer) installation in a manufactured

home or mobile home and must be installed in accordance with the manufacturer's instructions and the Manufactured

Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the United States or the Mobile Home Standard,

CAN/CSA Z240 MH Series, in Canada. This appliance is only for use with the type(s) of gas indicated on the rating plate.

A conversion kit is supplied with the mobile home appliance.

This Mobile/Manufactured Home Listed appliance comes factory equipped with a means to secure the unit. The ﬁ replace is

equipped with two 1/4" diameter holes located in the front left and right corners of the base. For mobile home installations,

the ﬁ replace must be fastened in place. Use #10 hex head screws, inserted through the holes in the base to secure. Always

turn off the pilot and the fuel supply at the source, prior to moving the mobile home. After moving the mobile home and prior

to lighting the ﬁ replace, ensure that the logs are positioned correctly.

This appliance is certiﬁ ed to be installed in an aftermarket permanently located, manufactured (mobile) home, where not

prohibited by local codes.

This ﬁ replace is only for use with the type of gas indicated on the rating plate. This ﬁ replace is not convertible for use with

other gases, unless a certiﬁ ed kit is used.

Conversion Kits

The mobile home appliance is ﬁ eld convertible between Natural Gas (NG) and Propane (LP).

To convert from one gas to another consult your Napoleon® dealer/distributor.

NOTE: All gas connections must be contained within the ﬁ replace when complete.

1. Move the ﬁ replace into position and secure to the ﬂ oor through the 1/4" holes

located at either side of the base.

2. The ﬁ replace is designed to accept 3/8" gas supply line. The ﬁ replace is equipped

with a 3/8" manual shut-off valve.

3. Connect the gas supply in accordance to local codes. In the absence thereof,

install according to the National Installation Code.

4. When ﬂ exing any gas line, support the gas valve so that the lines are not bent

or kinked.

5. Check for gas leaks by brushing on a soap and water solution.

Purge all gas lines with the glass door of the stove removed. Assure that a continuous gas ﬂ ow is at the burner

For ease of accessibility, an optional remote wall switch may be installed in a

convenient location. A 20ft length of millivolt wire is connected to the gas valve

for the wall switch. However, if a greater length is required route 2-strand (solid

core) millivolt wire through the electrical hole located at the bottom left side of

the unit. The recommended maximum lead length depends on wire size:

Attach the two leads to terminals 1 and 3 located on the gas valve.

Do not connect either the wall switch, thermostat or gas valve directly to

110 volt electricity.