Sony HDC-950 Manual page 75

7 AUDIO IN (auido input 1, 2) connectors (BNC
type) and switches
Connect audio signals. An input select switch and
microphone power switch are provided for each
channel.
Input select switches
Microphone power switches
LINE MIC OFF+48V
AUDIO
IN
CH-1
Input select switch: Set to the appropriate position
according to the connected eqiupment.
LINE: When a line-level signal source is
connected
MIC: When a microphone is connected
Microphone power switch: When a microphone is
connected, set whether or not to supply a power to
the microphone.
+48V: To supply a power of +48 V
OFF: Not to supply a power
•: To supply a power of +12 V
Note
To supply a power of +12 V, modification of the
camera is required.
For details, refer to the Installation & Maintenance Manual.
Note that the modification must be performed by a service
personel only.
8 RET CONT (return control) connector (6-pin)
Used for connection to a CAC-6 Return Video
Selector.
9 EXT I/O (external input and output) connector
(20-pin)
Used to supply signals, such as Y/Pb/Pr signals, to
external equipment.
0 REMOTE connector (8-pin)
Used for connection to an RM-B150 Remote Control
Unit, RCP-700-series Remote Control Panel or MSU-
700A/750 Master Setup Unit.
LINE MIC OFF+48V
CH-1
qa DC OUT (DC power supply output) connector
(4-pin)
Used to supply power to devices such as a wireless
receiver (optional).
qs DC IN (DC power supply input) connector
(XLR 4-pin)
Used for connection to the AC-550/550CE AC
Adaptor, a battery etc. to supply power to the camera.
qd HD SERIAL OUT connector (BNC type)
Used for output of HD SDI serial data.
qf VTR connector (26-pin)
Used for connection to a VTR (such as the HDW-250)
or HDCD-50 HD Signal Distributor.
Chapter 2 Locations and Functions of Parts
2-7(E)