Intel I440 LX User Manual page 16

QUICK POWER ON SELF TEST:
THIS CATEGORY SPEEDS UP POWER ON SELF TEST. (POST) AFTER
YOU POWER ON THE COMPUTER, IF IT IS SET TO ENABLE, BIOS WILL
SHORTEN OR SKIP SOME CHECK ITEMS DURING POST.
ENABLE : ENABLE QUICK POST
DISABLED: NORMAL POST
BOOT SEQUENCE:
THIS CATEGORY DETERMINES WHICH DRIVE COMPUTER SEARCHES
FIRST FOR THE DOS (DISK OPERATING SYSTEM). DEFAULT VALUE IS
A,C.
A,C: SYSTEM WILL FIRST SEARCH FOR FLOPPY DISK DRIVE THEN
HARD DISK DRIVE.
C,A: SYSTEM WILL FIRST SEARCH FOR HARD DISK DRIVE THEN
FLOPPY DISK DRIVE.
SWAP FLOPPY DRIVE:
THE SWAP FLOPPY DRIVE. DEFAULT VALUE IS DISABLED. ENABLED:
FLOPPY A&B WILL BE SWAPPED UNDER THE DOS DISABLED:
FLOPPY A&B WILL BE NOT SWAPPED.
BOOT UP FLOPPY SEEK:
DURING POST, BIOS WILL DETERMINE IF THE FLOPPY DISK DRIVE
INSTALLED IS 40 OR 80 TRACKS. 360K TYPE IS 40 TRACKS WHILE
720K, 1.2M AND 1.44M ARE ALL 80 TRACKS. THE DEFAULT VALUE IS
ENABLED.
BOOT UP NUMLOCK STATUS:
THE DEFAULT VALUE IS ON.
ON: KEYPAD IS NUMBER KEYS.
OFF: KEYPAD IS ARROW KEYS.
BOOT UP SYSTEM SPEED:
IT SELECTS THE DEFAULT SYSTEM SPEED-THE SPEED THAT THE
SYSTEM WILL RUN AT IMMEDIATELY AFTER POWER UP.
HIGH: SET THE SPEED TO HIGH.
LOW: SET THE SPEED TO LOW.
I440LX 13
Ver.6LX2