Disassembly Joystick Box
Detach BUS cable (26) from the joystick box (1).
Loosen screw (30), open clamp (29) and detach joystick box (1) from the receiving tube (4).
Assembly
The assembly is performed in the reverse order.
Disassembly Motor
Detach actuator connection cable (38) from the wheelchair and put aside.
Remove locking ring (17) from the bolt (14) to separate the actuator (8) from the backrest holder (2).
Loosen nut (37) completely and detach together with washer (25).
Support actuator (8), remove screw (19) and detach the actuator from the swivel arm (3).
Assembly
The assembly is performed in the reverse order.
Disassembly Switch Box
Detach connection cable (38) from the wheelchair and put aside.
Loosen nut (13) completely and detach together with screw (27).
Detach switch box (28) from the switch box rod (5).
If necessary, loosen wing screw (24) and detach switch box rod (5).
Assembly
The assembly is performed in the reverse order.
Disassembly Holder, complete
Remove joystick box (1) as described above.
Remove actuator (8) as described above.
Remove switch box (28) and switch box rod (5) as described above.
Loosen clamping lever (23) and remove together with screw (22) and washer from the receiving tube (4).
Detach receiving tube (4) together with clamps (21) carefully from the swivel arm (3) and clear the BUS
cable (26) in the process.
Remove the BUS cable (26) completely from the swivel arm (3) and detach from the wheelchair.
Remove cap (16), loosen nut (15) and detach the swivel arm (3) with bushing (20) and washers (18) from
the backrest holder (2).
Detach swivel arm (3) from the backrest holder (2).
Loosen wing screws (24) and clamping lever (23) respectively, and detach backrest holder (2) from the
holding pieces (31 and 33 respectively).
Loosen nuts (13) together with screws (12) and detach clamping piece (11) from the backrest holder (2).
Remove cap (16), loosen nut (15) and detach bolt (14) from the clamp (11).
Recaro seat:
Standard / Comfort seat
If necessary, remove slide pieces (9 and 10 respectively).
Assembly
The assembly is performed in the reverse order.
100
Loosen 4 nuts (13) and detach together with washers (32).
Remove screws (27) and detach holder (31) from the seat.
Loosen Phillips screws (34) and detach holder (33) with rosettes (35) from
the backrest.