Protect A New Network Between 2 P-Link 0.2; Expand An Existent Network By Adding A New P-Link 0.2; Remove A P-Link 0.2 From An Existent Network; Speed Increase - Tele System P-LINK 0.2 User Manual

2.4.1.1 Protect a new network between 2 P-Link 0.2

Once that 2 P-Link 0.2 are connected as explained in section 2.3.3, press on each device the security button and
held on for 1 secondo (within 2 minutes). Now the network is protected from any unauthorized access.

2.4.1.2 Expand an existent network by adding a new P-Link 0.2

If the network is encrypted by using security button, press (for 1 second) the security button of one of the installed
powerline and then press the security button on the new powerline (for 1 second) within 2 minutes. Now the new
P-Link 0.2 is connected to the existent network. In order to add other P-Link 0.2 you need to do again the same
procedure described above.

2.4.1.3 Remove a P-Link 0.2 from an existent network

In order to remove a P-Link 0.2 from your network, press for about 10 seconds its security button. This device will
receive a random password and it will leave the previous network.

2.4.2 Speed Increase

In order to have better performances, please follow the suggestions below for avoiding interference issues:
• Avoid multiple power sockets. Wall power socket are strongly reccommended in order to have
maximum speed.
• Put the PC and/or network device not so close to P-Link 0.2 in order to avoid interference.
• Do not use the same multiple power socket for 2 different powerlines.
TELE System
5