Table of Contents
Advertisement
Chapter
Places that may be exposed to rain, such
28
as close to the door or on the vehicle's
floor.
Install this product horizontally on a
surface within 0 to 30 degrees tolerance
(within 5 degrees to the left or right).
Improper installation of the unit with
the surface tilted more than these toler-
ances increases the potential for errors
in the vehicle's location display, and
might otherwise cause reduced display
performance.
30°
When installing, to ensure proper heat
dispersal when using this unit, make sure
you leave ample space behind the rear
panel and wrap any loose cables so they
are not blocking the vents.
Leave ample
5 cm
space
5 cm
5cm
Installation using the screw
holes on the side of this product
Fastening this product to the fac-
tory radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the
bracket, and tighten the screws at three
locations on each side.
64
En
If the pawl interferes with installation,
you may bend it down out of the way.
1
4
3
2
1 Factory radio-mounting bracket
2 Dashboard or console
3 Frame
In some types of vehicles, discrepancy
may occur between the unit and the
dashboard. If this happens, use the sup-
plied frame to fill the gap.
4 Truss head screw
Be sure to use the screws supplied with
this product.
Installing the microphone
Install the microphone in a place where
its direction and distance from the driver
make it easiest to pick up the driver's
voice.
Be sure to turn off (ACC OFF) the product
before connecting the microphone.
Mounting on the sun visor
1 Fit the microphone lead into the
groove.
1
2
1 Microphone lead
2 Groove
2 Attach the microphone clip to the
sun visor.
1
2
1 Microphone clip
2 Clamps
Use separately sold clamps to secure the
lead where necessary inside the vehicle.
Install the microphone on the sun visor
when it is in the up position. It cannot rec-
ognize the driver's voice if the sun visor is in
the down position.
Installation on the steering
column
1 Detach the microphone base from
the microphone clip by sliding the
microphone base while pressing
the tab.
1
2
4
3
1 Microphone
2 Tab
3 Microphone base
4 Microphone clip
2 Mount the microphone on the
steering column.
Install the microphone on the steering
column, keeping it away from the steering
wheel.
1
Advertisement
Table of Contents
