www.freeservicemanuals.info
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
break-down because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repain parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission, ob-
serve from more than 30 cm away from the objective lens.
LASER DIODE AND FOCUS SEARCH OPERATION
CHECK
Carry out the "S curve check" in "CD section adjustment" and check
that the S curve waveform is output three times.
SAFETY-RELATED COMPONENT WARNING !!
COMPONENTS IDENTIFIED BY MARK ! OR DOTTED LINE
WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
TABLE OF CONTENTS
.......................................................................... 4
2-1. Front Panel ........................................................................... 5
2-2. Main Board ........................................................................... 6
2-7. Base Unit ............................................................................. 8
2-8. Disc Table ............................................................................. 8
6. DIAGRAMS
6-1. Circuit Boards Location ...................................................... 18
6-2. Brock Diagrams
• CD Section ....................................................................... 23
• Deck Section .................................................................... 25
• Main Section .................................................................... 27
• Power Section .................................................................. 29
6-3. Printed Wiring Board -CD Section - .............................. 31
6-4. Schematic Diagram - CD Section - ............................... 33
6-5. Printed Wiring Board
6-6. Schematic Diagram
-Tuner (AEP, UK model) Section - ................................ 37
6-7. Schematic Diagram
-Tuner (East European, CIS model) Section - ............... 39
6-8. Printed Wiring Board
-Tuner (East European, CIS model) Section - ............... 41
6-9. Printed Wiring Board - Main Section - .......................... 42
6-10. Schematic Diagram - Main Section - .......................... 45
6-11. Schematic Diagram - Deck Section - .......................... 49
6-12. Printed Wiring Board - Deck Section - ....................... 53
6-13. Schematic Diagram - Panel Section - ......................... 56
6-14. Printed Wiring Board - Panel Section - ....................... 59
6-15. Schematic Diagram - Power Section - ........................ 63
6-16. Printed Wiring Board - Power Section - ..................... 67
6-17. Schematic Diagram - CD Motor Section - .................. 70
6-18. Printed Wiring Board - CD Motor Section - ............... 71
- 3 -
It`s Free
9
11
............................... 11
........................................ 98