Advertisement
on the mantel. Each Plastic Connector needs 3 holes. See Fig. C.
Fig. C
3. Gently install the KD NUTS into the drilled-holes with hammer as shown in Fig. D.
4. Attach the PLASTIC CONNECTOR and lock in place with KD SCREWS as shown in
Fig. E.
Fig. E
OptiON 2:
Use the SMALL L-BRACKETS and SCREWS
1. Place the SMALL L-BRACKET to the unit as shown and mark the drill-holes on the
mantel as shown in Fig. F.
Fig. F
2. Drill the holes with diameter 1/16 inches (2 mm) and depth 5/16 inches (8mm) on
the mantel. Each SMALL L-BRACKET needs 4 holes. See Fig. G.
Fig. D
Fig. G
3. Attach the SMALL L-BRACKET and lock in place with SCREWS as shown in Fig. H
CLEANING
To clean unit first turn off controls on unit and unplug the unit from power source. To
clean glass display panel; remove dust with clean dry cloth or to remove finger prints
and other marks clean glass with clean damp cloth. Do not use abrasive cleaners or
spray liquids on glass display panel surface. Metal and metal painted parts should
be cleaned with damp cloth. Do not use abrasive cleaners or spray liquids on these
surfaces.
WARRANTY
Every electric fireplace heater is tested before it leaves the factory and it is guaran-
teed for one year. If the unit should fail to operate correctly within one year from
the date of purchase, call customer service at 1-800-459-4409 (EST). We will, at our
discretion either repair or replace the unit. It will have to be returned to us freight
prepaid and we will return the repaired or replaced unit to you freight prepaid. The
company's sole obligation is to repair or replace the unit. This warranty is void if in
the opinion of Quality Craft the unit has been tampered with, altered, misused, dam-
aged, abused or used with the wrong power source. Light bulbs are not covered by
this warranty. The warranty is for homeowner use only and does not cover units used
in commercial situations.
Imported by
Quality Craft
Laval, Quebec, Canada H7S 2G7
1-800-459-4409 (EST)
www.qualitycraft.com
Made in China
6
Fig. H
Advertisement
