Advertisement
WarNiNG: Do not mix old and new batteries Do not mix alkaline, standard
(Carbon-Zinc), or rechargeable (Nickel Cadmium) batteries.
MAINTENANCE
MaiNtENaNcE WarNiNG: Disconnect power and unplug the power cord
before attempting any maintenance or cleaning to reduce the risk of fire, electric
shock or damage to persons. The bulbs in your unit can become extremely hot.
Allow at least 10 minutes between turning off the unit and removing the light bulbs
to avoid the accidental burning of the skin.
riSK OF FirE: DO NOt ExcEED tHE rEcOMMENDED BUlB WattaGE.
REPLACING THE LIGHT BULBS
Step 1: Remove 14 screws on the back of fireplace and open the rear cover.
There are 2 larger screws and 12 smaller screws
Step 2: You will find 1 X 40W Type B-10 bulb under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the larger screws into the top left corner hole
and bottom right corner holes as shown in the diagram. Secure the 12
smaller screws into the remaining holes. Make sure the screws are in the
correct holes and have been tightened.
Step 5: Plug in the unit.
REPAIR SET
TOUCH-UP REPAIR PAINT
1.Paint directly on the mantel unit if necessary. Fig. A
Fig. A
REPAIRS
If any problems are found with the original parts during mantel assembly such as
the panels cannot be installed with the plastic connector. Try to solve by one of the
following methods.
Tools required: Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm),
pencil, hammer, Philips screwdriver, safety goggles and gloves (if necessary).
WarNiNG: Wear goggles before you start drilling.
OptiON 1:
Use the spare KD NUTS, KD SCREWS and PLASTIC CONNECTOR
1. Place the PLASTIC CONNECTOR on the mantel unit and mark the drill-holes as
shown in Fig. B.
Fig. B
2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10mm)
5
Advertisement
