Philips FC 6842/A Service Manual

!
Service
Information
Philips Domestic Appliances and Personal Care
Service Manual
PRODUCT INFORMATION
Type no.
name : HR 68xx Triathlon (dry, wet and shampoo)
Versions : FC 6842 = blue
Voltage : 230 V a.c. 50 Hz; 240 V a.c. 50 Hz
Power : 1300 W (IEC) / 1500 W max.
Air
displacement : 51 l/sec. measured without accessories
Vacuum
(water col.) : 230 cm measured without accessories
Noise level : 77 dB
Capacity : Supply tank
Recovery tank
Recovery tank
Dust bag (HR 6947) 10 litres dry (39)
Cord length : 6.3 or 9.3 m (depends on the national version)
Shampoo
system : Motorised pump
Air exhaust : AFS-MICRO fi lter FC 8032
Dimensions : 46 x 45 x 32 cm
Net weight : 8.3 kg (without tools)
OPTIONAL
FC 8032 : AFS-MICRO fi lters
4822 015 70056. Item 20
HR 6947 : Athena 8836 947 01000 = 4822 015 70058
Contains: 4 Paper dust bags, 1 motor fi lter
and 1 AFS-MICRO fi lter. Items 29, 24 and 20
HR 6965 : Cleaning liquid for carpets
4822 390 80176
FC 8043 : Turbo nozzle
FC 8042 : Twist and clean nozzle
Published by Philips Domestic Appliances and Personal Care
4322 277 00898
02/03
3 litres (2)
9 litres wet (7)
17 litres dry (7)
Printed in the Netherlands

Vacuum Cleaner

SERVICE INFORMATION
Accessories:
See drawing for replacing of the shampoo pressure hose, for
example the pistol handgrip.
Motor unit:
The type no. plate is placed on the outside of the lower
housing (38). To open the motor unit, remove the inlay
by pressing the inlay on the cord winder push-button and
remove 2 screws (E). (The inlay is mounted on the cover by
means of a snap construction).
Use a long Philips screwdriver 9965 000 08332 to remove
the 6 screws (F) of the lower housing / top housing. (Holes
in lower housing are 13 cm deep). For safety reasons, make
sure that the cap clamps do not come above the panel
surface (31) after replacing of the switch (30).
If the lower housing (38) must be separated from the top
housing (15) always replace waterproofi ng foam (22).
Press hard on the housing during assembly of this unit to
prevent the foam from moving during assembly.
This product meets the requirements regard-
ing interference suppression on radio and TV.
After the product has been repaired, it should
function properly and has to meet the safety
requirements as offi cially laid down at this
moment.
© Copyright reserved
FC 6842/A
Subject to modification