Adjusting The Assistance Level; Switching The Lighting On/Off; Speed And Distance Indicators - Bosch 1 270 020 900 Original Instructions Manual

English–4
"SPORT": Powerful assistance for
sportive riding off road as well as
for urban traffic
"SPEED": Maximum assistance,
supporting highest cadence for
sportive riding
To change the assistance mode, press the
"mode" button 4 until the desired mode is dis-
played in indicator e.

Adjusting the Assistance Level

In the set assistance mode, the assistance level
can be adjusted anytime, even during riding.
Note: For individual versions, it is possible that
the assistance level is pre-set and cannot be
changed.
A maximum of three assistance levels as well as
the assistance shut-off are possible.
Assistance
degree* at:
Assistance mode
"ECO"
"TOUR"
"SPORT"
"SPEED"
* The assistance degree can vary for individual versions.
To increase the assistance level, press the
button 6 until the desired level is displayed in in-
dicator c.
To decrease the assistance level, press the
button 7 until the desired level is displayed in in-
dicator c.
In assistance level "0", the drive is switched off.
The eBike can be operated as a normal bicycle
through pedaling.
0 276 001 XXX | (28.9.11)
Assistance level
"1" "2" "3"
30 % 60 % 100 %
60 % 95 % 140 %
75 % 110 % 200 %
90 % 160 % 250 %

Switching the Lighting On/Off

Depending on country-specific regulations, two
lighting versions are possible:
– The front light, rear light and display lighting
can be switched on and off at the same time
via the drive HMI.
– Only the display lighting can be switched on
and off; the front and rear light of the eBike
are independent of the drive HMI.
For both versions, the lighting is switched on by
pressing the "light" button 5. The lighting indi-
cator b appears on the display.
To switch off the lighting, press the "light" but-
ton 5 again; the lighting indicator b goes out.

Speed and Distance Indicators

Note: Depending on country-specific version,
distance and speed can either be displayed in
"km" and "km/h" or in "mi" and "mph". Adjust-
ment of the drive HMI and the selection of the
display possibilities for the km and mile version
are identical.
The speed indication a always displays the cur-
rent speed.
The following indications are available in multi-
function indicator d:
Total distance "odo": Indi-
cates the total distance cov-
ered with the eBike
Trip distance "trip": Dis-
tance covered since the last
reset
Average speed "avg": Aver-
age speed achieved since
the last reset
Range "range": Estimated
range of the available battery
charge (for constant conditions such as assist-
ance mode, assistance level, route profile etc.)
To switch within the multi-function indicator,
press the "info/reset" button 3 until the desired
function is displayed.
To reset the trip distance "trip" and the average
speed "avg", switch to one of both indications
and then press the "info/reset" button 3 until
the indication is reset to zero.
Bosch eBike Systems