Dismantling Instructions - Philips CDR600/00/17 Service Manual

Mechanical Instructions

DISMANTLING INSTRUCTIONS

See Exploded View for item numbers
CDR module includes :
Loader 81
CDR main board 1001
Loader bracket 82
⇒
Put the CDR player's rear side facing you.
⇒
Undo the 3 wire connections on the CDR
main board 1001.
⇒
Undo flexfoil cable connection on CDR main board.
⇒ → 93
Remove 4 screws 90
(loader bracket 82 to bottom cabinet 181)
⇒
Lift CDR module at rear side to remove.
Attention :
flexfoil cable 8001 is not part of the CDR module
and has to stay with CDR player in case of
CDR module exchange !
CDR600
Cover 151
⇒
Remove 7 screws 168
2 at each side and 3 at rear side.
⇒
Lift cover at rear side to remove.
I/O board 1004
⇒ ⇒
Put CDR player's rear side facing you.
⇒ Undo flex connection to CDR main board 1001. ⇒
⇒ Remove 3 screws 200 → 202, connecting ⇒
the 3 I/O sockets to back plate 266.
⇒
⇒ Remove board.
⇒
⇒
4. GB 27
assembling
↑
→ 174,
↓
disassembling
Power supply unit 1003
⇒
Put the CDR player's rear side facing you.
⇒
Undo the 2 wire connections on PSU.
Remove screw 205
(mains connector to back plate 266). ⇒
→
Remove 3 screws 189 191
(PSU board to bottom cabinet 181).
⇒
Unlock snap on spacer 186.
⇒
Remove PSU.
WARNING: POSSIBILITY OF HIGH
VOLTAGE (300V) ON HEAT SINK,
EVEN AFTER REMOUNTING OF
PCB. DISCHARGE ELCAP 2121.
Headphone/IR board 1002
⇒
Remove 2 screws 33 and 34
(headphone/IR board to front assy 1).
⇒
Remove bracket 2 .
⇒
Undo the 2 wire connections on board.
⇒
Remove board.
Front assy 1
Put the CDR player's front side facing you.
Remove screws 31, 32.
(ground wires to bottom cabinet 181)
Remove 2 screws 182, 183
(front assy 1 to bottom cabinet 181)
Unlock front assy from frame by releasing 6 snaps.
After disassembly put front assy 1 in front of the set
(service position)
Display board 1002
⇒
Remove easy jog knob 51 by pulling it forward.
⇒ → 30
Remove 10 screws 21
(display board to front assy 1).
⇒
Release snap in upper left corner of board.
⇒
Undo the 3 wire connections on display board.
⇒
Remove display board.
On/Off & Stby LED board 1002
⇒
Remove 2 screws 35 and 36
(on/off switch to front assy 1).
⇒
Undo the 2 wire connections on board.
⇒
Remove power button 9 from on/off switch.
⇒
Remove board.
280301