Service Hints; Dismantling Cd-Door - Philips AZ9218 Service Manual

SERVICE HINTS

REPAIR POSITION COPPERSIDE
To get access to the copperside of the
printed board assembly proceed as follows:
1. Remove the bottom screws (6x)
2. Lift the bottom-cabinet
3. Supply the unit via external DC-socket
4. Take care that the door switch is closed during
measurements
DISMANTLING THE CD-DOOR
To dismantle the CD-door proceed as follows:
1. Disconnect the membrane keyboard
(flex-foil connector on copperside of printed board)
2. Smoothly bend the bridge of the cabinet downwards as
shown in 1. Take care not to touch the lens
3. Smoothly pull out the right hinge of the CD-door as
shown in 2.
4. Lift the CD-door
CS 46 663
2-1
REPAIR POSITION COMPONENTSIDE
To get access to the componentside of the
printed board assembly proceed as follows:
1. Remove the bottom screws (6x)
2. Open the CD-door
3. Lift the top-cabinet and put it backwards on the table
4. Supply the unit via the external DC-socket
5. Take care that the door switch is closed during
measurements
Remark: Do not use screwdrivers or tools like that.
Sharp edges could damage hinge or cabinet part.