Table of Contents
Advertisement
1.3 Specifications
Version:
Connector Supported: UTP RJ45, BNC RG58
Standard:
Bus:
IRQ:
I/O Address:
Dimension:
Temperature:
Humidity:
1.4 Quick installation
This section outline the steps needed to install the EPC-0100TB, install the
software, and connect the card to the network.
1.
Install the EPC-0100TB (Refer to chapter 2).
Connect the media coupler to the EPC-0100TB, then insert the card into
the PCMCIA slot.
2.
Install the PCMCIA software (Refer to Chapter 3).
3.
Install the network software (Refer to Chapter 3).
Fehler! Formatvorlage nicht definiert.
EPC-0100TB (V2)
IEEE802.3 10Base-T, 10Base-2
16-bit interface and 16KB network data packet buffer
3, 4, 5, 9, 10, 12, and 15
300, 320, 340, 360
850 x 55 x 5 mm
o
o
0
C to 55
C
10% to 90% (Non-condensing)
9
Advertisement
Table of Contents
