Troubleshooting; Maintenance - qleeno QS101 Operating Instructions Manual

After Each Use
1. Clean the hub insert and inside of the hub.
2. Empty water tank. Position Qleeno over a floor drain and hold Decrease Water Flow button down for 3 sec-
onds to empty clean water.
3. Clean brush/pad and squeegee ring.
Transporting Qleeno
CAUTION: Do not attempt lifting the entire machine without assistance. If transporting Qleeno a short dis-
!
tance, simply tilt the machine back on the transport wheels.
1. Unlock handle support locks, fold handle to lowest position and re-lock handle supports.
2. Lift front of machine and roll Qleeno with weight supported on transport wheels.

TROUBLESHOOTING

Qleeno will not start
Control panel Warning Indicator Light is on
Qleeno makes beeping sound and shuts off
Water will not flow after starting
Qleeno leaks water
Qleeno leaks water when lifted for transport
Qleeno drags or pulls in one direction while operating • Adjust casters (see pg. 5)

MAINTENANCE

WARNING: Do not remove the motor cover. Maintenance requiring removal of the cover should only be
!
performed by a qualified repair technician.
Changing the Fuse
Wait 15 minutes after shutting down before changing the fuse and attempting to restart the machine.
The fuse is a standard 115V/10A, and is located under the control panel, near the electrical connection.
Symptom Corrective Action
• Check electrical connection and fuse.
• Water tank is low. Empty dirty water and refill clean
water.
• Water tank is empty. Empty dirty water and refill
clean water.
• Check filters for clogging.
• Clean water tank seals.
• Verify Water Fill cap is tight and properly threaded.
• Check water pump on.
• Inspect water tank for damage.
• Check both caps on water tank firmly sealed.
8