qleeno QS101 Operating Instructions Manual page 10

Adjustment of Suction Hoses
NOTICE: Proper adjustment of the suction hoses is essential to good operation. Check hose adjustment on a
regular basis.
1. Pinch hose to allow insertion into squeegee ring.
2. End of suction hose should be approximately 1-3/16" from squeegee ring surface.
Weekly Maintenance
1. Make sure brush rotates freely.
2. Inspect water tank for leaks and that membrane separating clean and dirty water is in good condition.
Monthly Maintenance
1. Perform Weekly Maintenance.
2. Rinse water hoses by cleaning a section of a floor with a large amount of clean water.
3. Thoroughly clean gaskets around water tank.
4. Clean both fill and drain caps on water tank.
5. Clean inside of both clean water and dirty water tank.
After First 100 Hours of Use
Frequency of use and type of environment will dictate when some maintenence is performed. Lubricate casters
with silicone grease or spray. Inspect entire machine for damage, loose screws, nuts and other parts.
Yearly Maintenance
It is recommended that you take your Qleeno to the nearest authorized service center for thorough inspection.
Before long periods of inactivity
1. Perform Monthly Maintenance.
2. Empty machine of all water.
3. Lubricate gaskets with silicone grease.
After long periods of inactivity
1. Inspect gaskets and wipe away excess silicone grease.
2. Perform monthly maintenance.
Approximate Critical Component Expected Lifetime
Squeegee
Vacuum Tube
Brush
AC Motor
DC Motor (brush replacement)
600 hrs.
600 hrs.
1000 hrs.
1000 hrs.
2500 hrs.
10
Timing Belt
Water Pump
Water Tank
Casters
Transport Wheels
1500 hrs.
1500 hrs.
2000 hrs.
2000 hrs.
2000 hrs.