Page 1
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Protect your investment! Register your Qleeno at www.qleenousa.com SFA Companies, Inc.
• Do not modify this device mechanically or electrically. Do not attempt to alter or defeat safety devices in any way. • Never insert hands, feet or other foreign objects into or close to the brush mechanism while Qleeno is in operation. Always make sure the machine is disconnected when inspecting the rotating brush mechanism.
Page 3
• Do not release the handle while Qleeno is running. Always maintain positive control of the machine. Always turn off the machine when not in use. • Keep children away from this equipment. Qleeno is not a toy and may be dangerous in the hands of an untrained user.
PRODUCT DESCRIPTION Qleeno is an electric powered, low-profile, wet floor scrubber. It scrubs and dries in one pass, and utilizes water and any common household floor cleaner. Qleeno is intended for commercial use only and is not a consumer product.
Page 5
NOTICE: Follow chemical manufacturer's instructions when using cleaning agent. Use only non-foaming clean- ing agents. NOTICE: Qleeno is not intended to be used as a buffer. Do not fill water tank with wax. NOTICE: After removing water tank, always carry with drain end down - water tank can spill if carried incorrectly.
Page 6
Mounting the brush/scouring pad 1. With Kick Stand folded up, lift Qleeno to upright (vertical) position and turn brush/scouring pad holder counter- clockwise to remove it. 2. Mount brush and turn clockwise until it contacts mounting tabs on hub (ref. photo below).
8. Warning Light (red) Normal Operation Best results can be obtained by always using a full tank of clean water and chemical (if required). Move Qleeno in slow, overlapping lines over one portion of the surface at a time. NOTICE: Change direction slowly - do not move Qleeno in sudden or jerking motions.
After Each Use 1. Clean the hub insert and inside of the hub. 2. Empty water tank. Position Qleeno over a floor drain and hold Decrease Water Flow button down for 3 sec- onds to empty clean water. 3. Clean brush/pad and squeegee ring.
Page 9
Cleaning the Hub WARNING: Always turn Qleeno completely off and disconnect it from the power source when not in use or before storing, making adjustments, changing brushes, performing any type of cleaning, maintenance, or repair work. NOTICE: The hub should be cleaned after each use to ensure optimum performance.
Page 10
Inspect entire machine for damage, loose screws, nuts and other parts. Yearly Maintenance It is recommended that you take your Qleeno to the nearest authorized service center for thorough inspection. Before long periods of inactivity 1.